DSC PC255O Specifikace stáhnout pdf (Strana 12)

UL LISTED

COMMERCIAL AND

RESIDENTIAL

INSTALLATIONS

The installation requirements listed below must be met for

the following grades of service.

Grade A

Local

The installation must have a bell UL Listed for mecantile

local alarms (AMSECO MBL10B with Model AB-12 bell

housing).

The digital communicator must be enabled.

The control panel must be in the Attack Resistant

Enclosure.

Grade B Central Station and

Grade A Police Connect

The installation must have a bell UL Listed for mecantile

local alarms (AMSECO MBL10B).

The digital communicator must be enabled.

The control panel must be in the Attack Resistant

Enclosure.

Grade C

Central Station

The digital communicator must be enabled.

The control panel must be in the Attack Resistant

Enclosure.

All Commercial Installations

• The entry delay must not exceed 60 seconds

• The exit delay must not exceed 60 seconds.

• The minimum bell cutoff time is 15 minutes.

Residential Installations

• The entry delay must not exceed 45 seconds

• The exit delay must not exceed 60 seconds.

• The minimum bell cutoff time is 4 minutes.

Programming

The notes in the programming sections describing the

system configurations for UL Listed installations must be

implemented.

Control of the Protected Premises

In order to have a UL Certificated system the protected

area is to be under the responsibility of one ownership

and management (i.e. one business under one name).

This may be a group of buildings attached or unattached

with different addresses but under the responsibility of

someone having mutual interest. The person of mutual

interest is not the alarm installing company.

Bell Location

The alarm sounding device (bell) must be located where

it can be heard by the person or persons responsible for

maintaining the security system during the daily arming

cycle.

Protection of the Control Unit

The local control and the local power supply must be

protected by one of the following ways:

• The control unit and audible alarm device must be in a

protected area which is armed 24 hours a day.

• Whenever any zone on the alarm system is armed then

the zone protecting the control unit and the audible

alarm device power supply must also be armed.

Access to this protected area, without causing an

alarm, will require that the alarm system be completely

disarmed.

In all cases described above, the protected area for the

control unit must be programmed as not bypassable.

Casual Users

The installer should caution the user(s) to not give system

information to casual users (e.g. codes, bypass methods,

etc. to baby-sitters or service people). Only the One-Time

Use codes should be given to casual users.

User Information

The installer should advise the users and note in the user

instruction manual:

• Service organization name and telephone number

• The programmed exit time

• The programmed entry time

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Komentáře k této Příručce

Žádné komentáře

DSC PC255O Specifikace Strana 12

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu DSC PC255O