DSC PowerSeries PC1864 Instalační příručka stáhnout pdf (Strana 17)

Section 4 – Programming Descriptions

Section [020] Keypad Zone Assignment

Enter the two-digit zone number to be assigned to each keypad assigned to a specific slot. Only one keypad can be assigned to a specific

slot. See Keypad Assignment. Valid entries are from [00] to [64].

Section [021] Eighth System Option Code

For Future Use

Section [022] Ninth System Option Code

Section [023] Tenth System Option Code

Section [030] Fast Loop Response

This section is used to determine the Loop Response Time for the main panel zones.

Section [101] to [164] Zone Attributes

These sections are used to customize the operation of the zones. There are 9 toggle options in each Section:

Option Description

[1-5] For Future Use

[6] Refer to the PC1616/PC1832/PC1864 Reference Manual for RF Delinquency details.

[7] Future Use

[8] ON: When the system is armed in Stay mode, during the Exit delay, the system will sound 1 beep every 3 second.

OFF: When the system is armed in Stay mode, the system will be silent during the Exit delay.

Option Description

[1] ON: the keypad [F] emergency key will only beep three times to acknowledge the button has been pressed. The system will not

activate the bell output. OFF: the system will activate the bell output and beep the keypad.

[2] Refer to the PC1616/PC1832/PC1864 Reference Manual for 200 Baud Open/Close Identifier details.

[3] ON: the system will only transmit the Test Transmission reporting code if the system is armed at the time the system is programmed

to report the event. OFF: the system will always report the Test Transmission reporting code at the programmed time.

[4] ON: the system changes the Test Transmission Reporting Cycle Time from Days to Hours. OFF: the Test Transmission Reporting

Cycle Time is in Days.

[5] ON: the user can switch from Away Arm mode to Stay Arm mode using the function keys. OFF: the user cannot switch arming

modes.

[6] ON: the system disconnects a listen in/two-way session if a new event occurs.

OFF: the system does NOT disconnect. New events are transmitted only after the session is terminated.

[7] ON: the system does NOT activate the keypad buzzer for any trouble condition. OFF: the system annunciates troubles via the

keypad buzzer (two beeps every 10 seconds) normally.

[8] For Future Use

ON: the loop response time will be 36 mS. OFF: the loop response time will be 400 mS.

Option Description

[1] ON: alarms are audible (bell output). OFF: alarms are silent.

[2] ON: the bell output is steady (burglary). OFF: the alarm output pulses (fire).

[3] ON: a zone violation or restoral will activate Chime. OFF: Chime is not activated.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 63 64

Žádné komentáře

DSC PowerSeries PC1864 Instalační příručka Strana 17