DSC PC1404 v1.1 Instalační příručka stáhnout pdf (Strana 65)

6 Testing & Troubleshooting



6 Testing & Troubleshooting

Testing:

• Power up system

• Program options as required (see Section 5 Programming Worksheets)

• Violate, then restore zones

• Verify correct Reporting Codes are sent to the central station

Troubleshooting:

• Power up system

• Enter [

][2] to view Troubles

• Perform actions indicated in the tables below

Trouble Summary:

Trouble [1] Service Required - Press [1] or  for more information:

1 - Low Battery

2 - Bell Circuit Trouble

3 - General System Trouble

4 - General System Tamper

5 - General System Supervisory

6 - Not Used

7 - PC5204 Low Battery

8 - PC5204 AC Fail

Trouble [2] - AC Trouble

Trouble [3] - Telephone Line Trouble

Trouble [4] - Failure to Communicate

Trouble [5] - Zone Fault - Press [5] or  for more information

Trouble [6] - Zone Tamper - Press [6] or  for more information

Trouble [7] - Not Used

Trouble [8] - Loss of Time or Date - Press  to program date and time

Trouble Cause Troubleshooting

Trouble [1] Service Required Press [1] to determine specific trouble

[1] Low Battery Main panel battery less than 11.1 VDC

Note: This trouble condition will not

clear until the battery voltage is 12.5

VDC min., under load.

Note: If battery is new, allow 1 hour for battery to charge.

Verify voltage measured across AC terminals is 16-18 VAC.

-Replace transformer if required.

Disconnect battery wire leads.

• Verify battery charging voltage measured across battery

leads = 13.70 - 13.80 VDC.

Connect battery, remove AC power.

• Verify measured voltage across battery terminals is 12.5

VDC min.

[2] Bell Circuit Bell+, Bell-...Open Circuit Disconnect Bell-/Bell+ wire leads, measure resistance of

wire leads.

• Open circuit indicates break in wiring or defective siren/

bell.

Jumper Bell+, Bell- with 1K resister (Brown, Black, Red)

• Verify trouble clears.

[3] General System Trouble PC5204 Output #1 Open Circuit If Output #1 is unused:

• Ensure that terminals O1, AUX are jumpered with 1K

resister (Brown, Black, Red).

If Output #1 is used:

• Disconnect wire leads from O1, AUX terminals, mea-

sure the resistance of the wire leads. Open circuit indi-

cates a break in the wiring.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 75 76

Komentáře k této Příručce

Žádné komentáře

DSC PC1404 v1.1 Instalační příručka Strana 65

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu DSC PC1404 v1.1