DSC Envoy NT9010 Instalační příručka stáhnout pdf (Strana 45)

Section 2.3: Changing Other NT9010 Functions

RF Jamming Detection Zone. . . . . . . . . . . . . . . . . . . . . . . . . . . Section [807]-[093]

2.3.7 Zone Tamper/

Fault Options

By enabling Tampers/Faults Do Not Show as Open, faults and tampers for wire-

less zones will not be annunciated, and will be hidden from the end user. If the

option is disabled, faults and tampers will be annunciated.

NOTE:

Once a zone is tampered or faulted, it must be completely

restored before the trouble condition will clear.

If the All System Tampers Require Installer Reset option is enabled, any zone

faults must be reset by entering [✱][8][Installer’s Code] before the system can be

armed. Auto-Arming and Keyswitch arming will also be prevented in the presence

of any zone fault.

NOTE:

The Auto Arm cancellation code will not be transmitted if arming

is inhibited due to a zone fault. The Auto Arm cancellation code will be

transmitted if arming is inhibited due to Latching Tamper.

Tampers/Faults Do Not Show As Open . . . . . . . . . . . . . . . Section [013], Option [4]

All System Tampers Require Installer Reset . . . . . . . . . . . . Section [701], Option [4]

2.3.8

Communicator

Dialing

If the Communicator Disable option is selected the system will never attempt to

call central station. If the Communicator is enabled, the system will attempt to call

central station when an event occurs that has a valid reporting code programmed

(see 2.3.12 CommunicatorReporting Codes on page 47). You must also pro-

gram a valid telephone number for the communicator to work.

Communicator Call Direction Options are used to select where the system will

send different kinds of reporting codes when events occur. You can choose to have

the system send reporting codes to:

• 1st telephone number

• 2nd telephone number

These options are programmed separately for each type of reporting code.

The different types of reporting codes are:

• Alarm/Restore codes

• Tamper Alarm/Restore codes

• Opening/Closing codes

• System Maintenance Alarm/Restore codes

• System Test Transmission codes

When the Force Dialing option is enabled, the system will dial out regardless of

the presence of dial tone. Each dialing attempt will follow this pattern:

a) the system picks up the telephone line and searches for dial tone for 5 seconds

b) if no dial tone is found, the system hangs up and waits for 20 seconds

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 67 68

Komentáře k této Příručce

Žádné komentáře

DSC Envoy NT9010 Instalační příručka Strana 45

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu DSC Envoy NT9010